Transmission fluid cahnge

[buck12]

Changed the transmission fluid for the first time in my 2615 gear. I added the required amount of fluid per the manual but the level did not even register on the dipstick. To get the fluid to full mark took almost more than a gallon more than the amount listed in the manual. I do understand that the FEL uses the same fluid. Is this the difference?

 

[bindian]

Changed the transmission fluid for the first time in my 2615 gear. I added the required amount of fluid per the manual but the level did not even register on the dipstick. To get the fluid to full mark took almost more than a gallon more than the amount listed in the manual. I do understand that the FEL uses the same fluid. Is this the difference?

Buck12,
If you serviced the transmission/hydraulic system with any cylinders extended................you'll have a low reading..............until they all retract.. ...........then you'll have an overfull reservoir. Take the cap off (maybe have a clean rag or towel over it as it could make a mess) the reservoir and slowly retract all cylinders........then check the level. I bet you will show about a gallon too much. Then again...........your manual may be wrong. I found this to be true on the capacity of my front axle and hugs.
hugs, Brandi

 

[buck12]

Cylinders were mostly retracted. The tractor was parked in the shop with the bucket level on the floor. Thanks for the reply.