TOP Position: BX2360 Deck

aczlan · Mar 21, 2014

snpower said:
So I adjusted the aforementioned bolt, and, she went into top. Then past top clockwise to 0,1... all the way around. Not sure if that is "normal ops" but the deck stays put now. Now onto adjusting this bad boy.

Thats how the deck on our BX2660 works...

Aaron Z

BXpanded · Mar 21, 2014

snpower said:
So I adjusted the aforementioned bolt, and, she went into top. Then past top clockwise to 0,1... all the way around. Not sure if that is "normal ops" but the deck stays put now. Now onto adjusting this bad boy.

Perfectly normal.

coveredbridge · Mar 22, 2014

snpower said:
I found this on adjusting to ensure deck stays up:

"The heght adjustment "Top" position holds the deck in the fully raised position regardless of the 3 point hitch position. Raise the deck completely and turn the height adjustment to "Top". If the knob won't turn to "Top", do the following:
Looking at the rear of the tractor, just inside the left rear tire is a linkage that controls the lift. There will be a gold colored bolt that faces rearward. Loosen the lock nut on the bolt and screw the bolt in one turn. Raise the mmm all the way and see if the knob will turn to the "Top" position. If not, turn the bolt another turn and try again. It shouldn't take more than a few turns of the bolt unless something else is out of adjustment."

I think the whole deck needs leveling. Not my specialty, for sure...

May I ask where you found that instruction? I have the same problem and I couldn't find anything in the operators manual.

snpower · Mar 22, 2014

coveredbridge said:
May I ask where you found that instruction? I have the same problem and I couldn't find anything in the operators manual.

I did not find it in there myself. There were/are several older discussions about it, the notes I posted came from the orange tractor talk site as it was the most concise explanation. It would be handy to have it in a sticky note on here; tricks/tips for the BX series... or maybe it's common knowledge. I've had my tractor since Fall 2010 and didn't know it would even stay all the way up!

Here is a link to an older TBN Discussion(s) on deck adjustment which mentions the TOP position. It sounds like Harry from BXpanded provided the comments I quoted in my reply above (PS to BXpanded: I am going to order one of those 'Piranha Tooth Bars' one of these days SOON !!! :

http://www.tractorbynet.com/forums/kubota-owning-operating/246142-bx-2360-60-deck-adjustment.html

http://www.tractorbynet.com/forums/kubota-owning-operating/270024-new-member-bx2360-mower-deck.html

coveredbridge · Mar 22, 2014

It took three full turns on the bolt, and then it worked just as you described. Thanks!

psvines · May 23, 2015

Thanks neighbor! I've been fighting this for weeks and your tip worked perfectly.

BXman98 · May 26, 2015

snpower said:
Should the deck still lower some when the height knob is set to TOP? I would be happier if it remained all the way up. This is where my 54" deck sits when I lower the 3pt hitch and the knob is set to TOP.

it looks like that your knob is set to 4, not to top. When you are sitting in the seat, turn the knob counter clockwise until the black arrow is pointing down at the word top. But the deck has to be raised all of the way up in order to do so.