top n tilt install questions for a dk45

[justforme]

has anyone put one or seen one installed on one?

tia
jim

 

[DK35vince]

I have top n tilt on my DK 35, which should be very similar to the DK 45 setup.
I have the factory dual rear remotes with CCM top n tilt cylinders.

 

[DK35vince]

What is it you want to know about TnT ?

 

[justforme]

</font><font color="blue" class="small">( What is it you want to know about TnT ?
)</font>

are you running them off the rear remotes or the controls you can get with the tnt?

do you have any pics?

jim

 

[DK35vince]

I'm running mine from my rear remotes .
Here is a picture of the control levers for the rear remotes

 

[DK35vince]

The rear remotes where my TnT cylinders plug in.

 

[DK35vince]

One more.
This is an older picture that shows the tie rod cylinders I use to run.
I am now using hydraulic top link and tilt cylinders from www.ccmachinery.com

 

[justforme]

thanks for the pics

i'll more than likely run mine off the remotes

i might end up running an electric solenoid valve so i can run a third cylinder for the offset of the rear blade.

 

[BigAl]

I have a DK45 that I set up the TNT on. I used the rear remotes to control it . It works fine .
Big Al