jigs_n_fixtures
Veteran Member
I have the TL200, on the T233, and the TX2000 on the T293.
I was looking over the manuals for them today and the TX2000 has/had a factory third function available, consisting of a diverter mounted on the crossbar between the loader arms out by the bucket.
I'm in Sacramento, taking care of my oldest sister, and want to order up some compression fittings so, I can add the diverter third function when I get home.
I have a couple of diverter valves in the parts cache, so I have them. But need a few compression fittings to cut the dump/curl hard lines and transition to rubber soft lines. I know what style of fittings; I need but am not sure whether the hardlines on the loaders are 10-mm or 3/8-inch.
Anybody out there who has either loader and set of calipers or micrometers, who can measure the od of the tubes and let me know?
Thanks, Jigs
I was looking over the manuals for them today and the TX2000 has/had a factory third function available, consisting of a diverter mounted on the crossbar between the loader arms out by the bucket.
I'm in Sacramento, taking care of my oldest sister, and want to order up some compression fittings so, I can add the diverter third function when I get home.
I have a couple of diverter valves in the parts cache, so I have them. But need a few compression fittings to cut the dump/curl hard lines and transition to rubber soft lines. I know what style of fittings; I need but am not sure whether the hardlines on the loaders are 10-mm or 3/8-inch.
Anybody out there who has either loader and set of calipers or micrometers, who can measure the od of the tubes and let me know?
Thanks, Jigs
