tire repair?

[ch1ch2]

Since this thread is in the welding forum,,,
I would try to weld the tire,,, get the New MILLER BOBCAT CUTIRE 200 welder,,
what shielding gas is required?

:laughing:

Now how the He** did that happen?
I know I clicked on tires and new thread!

But maybe your on to something...Is there a MILLER BOBCAT CUTIRE 200 Vulcanizer? Or maybe a blow torch vulcanizer?

 

[sailfast]

Sounds like they missed a few steps.

Repairing $30 000 Damaged GIANT Tire - Extreme Tire Repair Kit by REMA TIP TOP - YouTube

 

[Wolfy]

The rubber used in new tractor tires just is not as tough as it used to be. Back when I was a builder, my dad had a Pettibone forklift. I would say the rear tires were 30 years old and had cracks large enough that I could slide my fingers in, but in the 15 years we owned that machine, those tires never went flat.

 

[ch1ch2]

Looks like I will replacing it.

 

[CADplans]

Looks like I will replacing it.

It depends on where the cut is,,, but,,,

I have seen an AG tire have 1/8" holes drilled 1/2" from the slice,,
then, you simply "sew" the cut closed with stainless steel wire.

That held when I had my hernia operation,, I doubt your tractor could strain the tire any harder,,,


:laughing: