timing

[monkeyman]

hi.i got a mitsibushi k3h motor in my 3 ton digger.turned it off one day and would not start two days later.after a lot of trying i decided to rebuild.new rings ,honing,valves and a injector pump rebuild put her all together.still wont start,all the timing marks line up.anyone got an idea.fuel is getting thru after bleeding.
thanks

 

[Chilly807]

You may not have enough cranking speed for ignition. Load test or swap the battery, if that's ok then check the current draw on the starter. Either will cause a failed start.

Chilly

 

[monkeyman]

thanks chilly for that.theres no problem with the turn over speed.
i need to get in touch with anyone who has rebuilt one so therefore retimed it.
i have all the marks on the sprockets lined up.fuel at the injectors but not a hint of firing.its got to a timing issue.

mike