I just cleaned up and gave the NH tiller a few shots of grease since using last weekend. The left-hand side has a zerk, yet the right does not. Is the right a sealed bearing, or does the gear-oil bath take care of it?
I worked a nice amount of trash, grass, sand, etc. out of the groove where the tillers axle comes in contact with the frame. Seems as though a zerk allowing grease flow to blow this stuff out would aid in the life of the machine. However, neither does the left-hand side zerk allow this. add a little too much, and the release point in actually on the outside of the frame, where the greese cap is fitted.
I worked a nice amount of trash, grass, sand, etc. out of the groove where the tillers axle comes in contact with the frame. Seems as though a zerk allowing grease flow to blow this stuff out would aid in the life of the machine. However, neither does the left-hand side zerk allow this. add a little too much, and the release point in actually on the outside of the frame, where the greese cap is fitted.
