slammer3364
Bronze Member
- Joined
- Nov 27, 2010
- Messages
- 53
- Tractor
- Jinma 284
Anybody have any tips on getting tie rod end off Thanks
tie rod end
- Thread starter slammer3364
- Start date
- Views: 1698
Thomas
Epic Contributor
- Joined
- Apr 6, 2000
- Messages
- 31,188
- Location
- Lebanon,NH.
- Tractor
- Kubota B2650HSD w/Frontloader & CC LTX1046 & Craftman T2200 lawn mower.
Little more info...off what?
RalphVa
Super Member
- Joined
- Dec 19, 2003
- Messages
- 7,885
- Location
- Charlottesville, VA, USA
- Tractor
- JD 2025R, previously Gravely 5650 & JD 4010 & JD 1025R
Assuming from where they're into a tapered part with nut on end where the rotation takes place? They have tools for that. If you don't need to keep the tie rod intact, there's a forked tool that you drive in to separate the pieces. If you need to keep the tied rod and seal intact, they have a tool that is put over the rotation part and has a bolt that can be rotated to push the threaded part of the tie road out. Most auto parts stores would have these on sale or rental.
Be sure and precisely measure or could the # turns to remove the tie rod from the rod that goes between the wheels so that the alignment will be the same. This is after you have the other part extracted.
Ralph
Be sure and precisely measure or could the # turns to remove the tie rod from the rod that goes between the wheels so that the alignment will be the same. This is after you have the other part extracted.
Ralph
mrmikey
Veteran Member
If you're attempting to remove the tapered end from the boss, if you give the boss that the taper goes thru a good smack with a BFH it'll usually pop off. Hasn't failed me yet LOL...............Mike
RonMar
Elite Member
Yep, remove the nut, hit the part that the rod end bolts thru. A basic jaw puller clamped across the top of the threaded end to put a little force on it makes the smack method nearly foolproof...