The underside of my newer Kubota

[mx842]

I didn’t see any and decision to replace the line was based on the leakage.

Those lines have to remain in the exact same form as from the factory or they will leak.

If it was mine I would be tempted to tap the bores where the lines go in and replace them with a hose. I might even consider epoxying the fittings in the transmission side to avoid chips from tapping threads.

I was thinking maybe switching them to rubber but as long as it's under warranty I think I'll delay that until after the warranty is over. The o-ring fittings are good connections as longs as they go in straight, it's just that the iron pipe is so ridged there is no room to get them lined up without nicking one of the o rings. Hopefully the mechanic will have a solution.

 

[dieselscout80]

They are a pain to deal with.

Here’s my thread on a Kubota forum about the issue and fixing it.

L3301 Leak at Lines HST Transmission Filter

A friend has a L3301 with the hydrostatic transmission. The two lines with three connections shown in the attached pictures are leaking where the bolts hold them to the filter base/housing and the transmission housing. We replaced six orings and started it up and immediately it blew out two of...

www.orangetractortalks.com

 

[Topzide]

I second the idea of a skid plate! Could be made of pref steel with small holes to allow air and any water or possible leaks to drip.

 

[airbiscuit]

I'd leave it to the mechanic.

 

[TMGT]

I've been pretty lucky with my L3240 and not taking out anything on the underside so far.

I do have a backhoe subframe which would make a good mounting point for a skid plate. Guess I'll need to add that project to the list!

Sent from my SM-S921U using TractorByNet mobile app