Temp Gauge

Dsavage · Aug 20, 2012

Hey guys,
My old Electric temp gauge hasn't worked since I bought the tractor. So I replaced it with a Mech. one.
Question is, the gauge I bought doesn't threat into the block/tractor.
Are these Metric thread.? I'm guessing yes. and I'm not 100% sure what I bought, I didn't even look at the thread one the package.

oliver28472 · Aug 20, 2012

I put one on the grey beaver (1450). It came with adapters. I didn't have to remove the electric one, I found another port in the water pump. It had an allen plug in it. The sender screwed right in. Will probably put one on the Buck too.

Dsavage · Aug 20, 2012

ahhhhh I think I may have seen that..! So just plug the other one eh.?

Ilikeurtractor · Aug 20, 2012

I think the ports are standard NPT (national pipe thread) - at least I know NPT fittings will seal-up in them.

Dsavage · Aug 20, 2012

I'll have to check.. It seemed to thread in about one or two turns and stop.. I didn't want to force it.

evan price · Aug 23, 2012

Some Jap motors use British pipe thread for the senders and you need an adapter.

oliver28472 · Aug 23, 2012

That is true for the oil pressure switch. Valley Power gave the the part # for the adapter and I bought one at O'Reilly. I'm not sure about the temp though, the gauge I bought had adapters with it.