Telescopic draft links problem

corey9212 · May 4, 2013

Maybe giving it a shot of graphite might help? (The powder kind.)

SPYDERLK · May 4, 2013

Yes. Theres also a convenient aerosol called Slip Plate.
Amazon.com: slip plate

Grateful11 · May 5, 2013

Without reading back over all of it, are you pinning your stabilizers before trying to lock the slides in? I'd try leaving them unpinned and pin them after they slide in.

corey9212 · May 6, 2013

Grateful11 said:
Without reading back over all of it, are you pinning your stabilizers before trying to lock the slides in? I'd try leaving them unpinned and pin them after they slide in.

No, I leave the stabilizers unpinned until everything is hooked up

joshuabardwell · May 6, 2013

aczlan said:
On our L3830 I usually just lift the 3 point and they drop into place. Sometimes I have to push the bushhog back and forth, but its not a big deal.

Aaron Z

Same here. I lift the three point on order to center the implement and put the pins in the sway bars. Thats when I pop the lift arms back into place.