Taylor 962 Rototiller

[GregH]

I looked at one of these today for about 1325.00 delivered. It is a gear drive , about 630 lbs, i beleive it has 7 flanges and 6 blades per flange. Anyway anyone with personal knowldge of these and where the heck is the website?

Any help would be appreciated!!!
Greg Harrison

 

[DaddyRabbit]

Greg, I believe that you are referring to a Taylor Pittsburgh which in my eyes is the same thing as a KK unit. I looked at this one as well and I didn't walk away, I ran away. There are 2 choices on this forum, (First Choice and CCM). Both can be had in gear drive if the need be. I recently bought the gear driven first choice 14 model.

I looked at one of these today for about 1325.00 delivered. It is a gear drive , about 630 lbs, i beleive it has 7 flanges and 6 blades per flange. Anyway anyone with personal knowldge of these and where the heck is the website?

Any help would be appreciated!!!
Greg Harrison

 

[GregH]

Daddyrabbit,
Why run away. The KK by all accounts is okay. The CCM guy I talked to was rude as ****. I know that I should not use that as an excuse not to buy but it did leave a bad taste in my mouth. THe Taylor looked okay but I know that doesnt matter either. CCM is about 250 miles from me . I may have to make a road trip and check them out. Thanks for the advice! I will look at the CCM before buying.
Greg