npalen
Elite Member
Edit: Looks like a good way to bend a cylinder rod.
Edit: Looks like a good way to bend a cylinder rod.
LD1
Epic Contributor
Unlikely to bend a cylinder rod in tension
I'd watch the video but I don't have the patience to sit through 10 minutes of blathering by a guy who likes to hear himself talk about a subject he's clueless about for a 1 second clip that could have been a photo.
LD1
Epic Contributor
Am I seeing a different video? It was only 16 seconds long and showed how to fix the problem?
rScotty
Super Member
- Joined
- Apr 21, 2001
- Messages
- 9,496
- Location
- Rural mountains - Colorado
- Tractor
- Kubota M59, JD530, JD310SG. Restoring Yanmar YM165D
Interesting way to fix a bent SSQA. You want to get the wood just the right height.... or better yet use a split piece of pipe to lock the right hand cylinder, but worth a try.
OP
npalen
Elite Member
True that. It just looks like the 2x6 could cause a problem if it got caught under the end of the cylinder barrel
- Joined
- Feb 21, 2003
- Messages
- 26,859
- Location
- SE Michigan in the middle of nowhere
- Tractor
- Kubota M9000 HDCC3 M9000 HDC
I watch most YT vids for their entertainment value only.
- Joined
- Feb 21, 2003
- Messages
- 26,859
- Location
- SE Michigan in the middle of nowhere
- Tractor
- Kubota M9000 HDCC3 M9000 HDC
People for the most part like to hear themselves talk on most YT video's anyway.
OP
npalen
Elite Member
The guy must have a really good eye judging by how quickly he approved the straightening process. I would have had to squint and look about a dozen times and then grab a square, straightedge or something. 
ning
Elite Member
Probably was the 3rd try, did the same thing and got somewhere the first time, closer the second and figured the third time was the charmThe guy must have a really good eye judging by how quickly he approved the straightening process. I would have had to squint and look about a dozen times and then grab a square, straightedge or something.