I have removed left steering cylinder on TC33D w/Super Steer and purchased a new steering rod (old One was visibly bent and leaking) and seal kit. I have end open with spanner wrench but can only pull old rod and piston half way out. Is there a trick to removing the old rod or is this an indication my cylinder is also bent so the piston gets stuck?
Steering cylinder rod replace help, TC33D
- Thread starter Ltowne1
- Start date
- Views: 6201
thclimer
Veteran Member
Welcome to TBN.
Sorry I'm not that familiar with the parts you are having an issue with. Hopefully someone else will post with more knowledge about the hydraulic steering than I have.
Sorry I'm not that familiar with the parts you are having an issue with. Hopefully someone else will post with more knowledge about the hydraulic steering than I have.
RickB
Super Star Member
- Joined
- Sep 18, 2000
- Messages
- 15,190
- Location
- Up the road from Dollar General WNC
- Tractor
- Just a Scag
Good explanation of the importance of disassembly prior to ordering parts.
Sunny Creek Acres
New member
- Joined
- Aug 27, 2024
- Messages
- 1
- Tractor
- New Holland TC33DA
Howd you get the left steering cylinder off the tractor? I tried disconnecting from the left front wheel, but I couldn’t pull the cylinder down enough to get it off of the bolt. It must be attached somewhere up in the frame. How did you get that off?
thclimer
Veteran Member
The attached is for the next size larger frame (35, 40, 45) New Holland but maybe it will give you some insight if they are similar?