Hi, new member here.
Have Shenniu 254 purchased in 97. Been setting most of these years. Needed it so got it going again.
Had it running a few minutes, ran fine. Stopped it using the compression release. Started several times ok. Someone stopped it using the fuel shut off pull. Not long after it shut down on its own. No fuel to engine. Can pump fuel just fine with the hand pump but does not feed to cylinder lines when cranked. Pulled cap off and pump pistons looked fine, clean. Took it to a tractor place but they seem unsure. Would love any advice short of dynamite.
George Rowe cabinnnn@bellsouth.net or here , thanks.
Have Shenniu 254 purchased in 97. Been setting most of these years. Needed it so got it going again.
Had it running a few minutes, ran fine. Stopped it using the compression release. Started several times ok. Someone stopped it using the fuel shut off pull. Not long after it shut down on its own. No fuel to engine. Can pump fuel just fine with the hand pump but does not feed to cylinder lines when cranked. Pulled cap off and pump pistons looked fine, clean. Took it to a tractor place but they seem unsure. Would love any advice short of dynamite.
George Rowe cabinnnn@bellsouth.net or here , thanks.
