Servis box blade

[HAYSDANNY]

Looking for Rippers for my Servis box blade

 

[deereman75]

Looking for Rippers for my Servis box blade

are you wanting to make or buy them?

 

[HAYSDANNY]

WOULD BUY IF NOT OUTRAGUS LOCAL DEALER SAID THEY COULD GET THEM FOR $100.00 EACH

 

[Shield Arc]

Have you checked with this outfit? Their website is a little hard to get around in, but they have a lot of stuff!

Agri Supply - Farm Supplies, Tools, Lawn Mower Blades, Cast Iron Cookware

 

[deereman75]

I think the rippers would be fairly easy to make with an O/A torch, and a large angle grinder, just make a pattern, torch out the shapes, and grind until perfect. $100 sounds like alot per ripper, are you sure they meant $100 PER TOOTH?

 

[Shield Arc]

When I built my ripper / counterweight I bought the shanks from Agri-Supply. Back then they were about $9.00 a piece.

Agri Supply - Search

 

[yomax4]

I built a makeshift tooth bar for my back blade out of Railroad Spikes. Rippers a different but Spikes could be engineered at an angle to do a fair job on a box scraper too. Plus they are usually Free and very hard.

 

[Degolyerent]

What does the teeth look like? Do they have holes in center or notches in front or back? Teeth are available for less than the price you where quoted, the types I mentioned are about 20-30 bucks each and come in different lengths( regular or long)

 

[Brad_Blazer]

Welcome to TBN Danny!

If it's like this it's the standard front notch design.
http://support.servis-rhino.com/RhinoManuals/Parts/Rear_Blades/01200260P--- BOX BLADE PUB 04-10.pdf

Maybe you ordered these already? Let us know how you made out.
BOX BLADE SHANK 17.52'' LONG, 3 SLOT - Agri Supply