Scalp wheel bracket for a Kubota mower
- Thread starter Willis53
- Start date
- Views: 7926
WranglerX
Super Member
By the Messick site it looks to be part of the mow deck .....
Get a welder and learn to weld....
Kubota RCK60B23BX (60" SIDE DISCHARGE MOWER) Parts
Kubota RCK60B23BX (60" SIDE DISCHARGE MOWER) Parts
www.messicks.com
Get a welder and learn to weld....
Last edited:
WranglerX
Super Member
Sorry... I though you meant the "bracket" that holds "anti-scalp wheel assembly" (parts 020 through 060 ) to deck....
Did you really mean the (060) K5221-72680 PIN....
Did you really mean the (060) K5221-72680 PIN....
Last edited:
- Joined
- Jul 4, 2003
- Messages
- 2,594
- Location
- Viburnum, MO
- Tractor
- Kubota BX2200, LS XG3135H, Grasshopper and Yazoo Zturns
I had one rot through at the right corner. I just cut some 1/4 plate and welded it back in where it was rusted out. As far a I know you'll have to get a new or used deck to replace the welded on brackets. If it the center wheel it will take a bit more diligence to fabricate since that includes the front mount. I see stripped decks on craigslist fairly often.
RjCorazza
Elite Member
WranglerX provided a thoughtfully prepared answer to what I also believed your question to be.
You were also provided with a polite reply to a rather impolite post.
Good luck with your project.
For some reason the diagram did not load, just the reply, sorry about that. I am wanting the bracket, mine is past welding. I was hoping there was some kind of replacement for it. I think I can use where the spindle goes through and make a new one.
WranglerX
Super Member
Possible try a better browser for your cell phone/PC/tablet.... All browsers and browsing apps are not equal ....
