Egon
Epic Contributor
Good show!
It's always nice when you run into someone who has the knowledge and time to share.
It's always nice when you run into someone who has the knowledge and time to share.
Robin Generator - No power
- Thread starter alchemysa
- Start date
- Views: 10565
biggerten
Gold Member
Put some sort of 'goop' over that (and the solder joints on the back) for protection. And not just anything, a lot of silicone rubber is not 'electronics safe'.
Oh, and get a little tube of heat sink grease (at Radio Shack or the Aussie equivalent), that ensures the SCR has good heat sinking. Be careful with it, though, is is conductive, and that tab on the SCR package where the nut goes is 'live'. Maybe your new buddy can give you some pointers.
Good on ya, mate.
Oh, and get a little tube of heat sink grease (at Radio Shack or the Aussie equivalent), that ensures the SCR has good heat sinking. Be careful with it, though, is is conductive, and that tab on the SCR package where the nut goes is 'live'. Maybe your new buddy can give you some pointers.
Good on ya, mate.
RonMar
Elite Member
Now that is cool!
Soundguy
Old Timer
- Joined
- Mar 11, 2002
- Messages
- 52,424
- Location
- Central florida
- Tractor
- RK 55HC,ym1700, NH7610S, Ford 8N, 2N, NAA, 660, 850 x2, 541, 950, 941D, 951, 2000, 3000, 4000, 4600, 5000, 740, IH 'C' 'H', CUB, John Deere 'B', allis 'G', case VAC
As biggertensaid.. if the old scr used a mica insulator.. you also need to use one..
soundguy
soundguy
biggerten said:
Normal heat sink grease- the clear silicone and the more common white zinc oxide grease are not conductive. There are electrically conductive thermal greases available but they aren't very common, at least not here in the US.
Soundguy
Old Timer
- Joined
- Mar 11, 2002
- Messages
- 52,424
- Location
- Central florida
- Tractor
- RK 55HC,ym1700, NH7610S, Ford 8N, 2N, NAA, 660, 850 x2, 541, 950, 941D, 951, 2000, 3000, 4000, 4600, 5000, 740, IH 'C' 'H', CUB, John Deere 'B', allis 'G', case VAC
Maybee he meant thermally conductive? in any case.. a mice or thermal rubber/silicone pad will be the ticket.. as well as a grommet to insulate the lock down screw..
soundguy
soundguy
jinman
Rest in Peace
- Joined
- Feb 23, 2001
- Messages
- 21,059
- Location
- Texas - Wise County - Sunset
- Tractor
- NHTC45D, NH LB75B, Ford Jubilee
alchemysa said:
To quote Rocket J. Squirrel, "Teeeerific!"
What a stroke of luck and a credit to your persistence.
biggerten
Gold Member
Skyco is correct, the stuff we used at work was electrically conductive and I used to broad of a stroke.
It's messy stuff, though, and you still should use the absolute minimum needed, a Sil-pad is a good alternative.
It's messy stuff, though, and you still should use the absolute minimum needed, a Sil-pad is a good alternative.
