Replacing Hydro-Gear seals without diassembling

   / Replacing Hydro-Gear seals without diassembling #1  

whiskywizard

Silver Member
Joined
Jan 24, 2011
Messages
247
Location
Southern Ontario, on Lake Ontario
Tractor
KIOTI CK20S HST
Hello folks,
I've got a 2011 Toro Titan zero-turn with Hydro-Gear ZT-2800 drives. I've got a leaking input shaft seal on one unit. I'd like to replace the seal externally. That is, pull it from the outside without dismantling the whole hydraulic drive. I've done it before on less crucial things, like snowblower output shafts. Has anyone got first-hand experience on this one, or similar?

The seal is part no. 56.

Screen Shot 2019-06-02 at 16.52.27.png
 
   / Replacing Hydro-Gear seals without diassembling #2  
I think you mean #56 and judging by the drawing _only_ it could be removed after the snap ring (57) is out.
 
   / Replacing Hydro-Gear seals without diassembling
  • Thread Starter
#3  
Yes, part 56. Typo.

Thats' what I was thinking Chuck. I've had success before by driving 2 small screws through a seal and pulling it out.
 
   / Replacing Hydro-Gear seals without diassembling #4  
Is part 54 a o-ring? Usually there’s the dust seal part 56 and a deeper high pressure oil seal.
 

Tractor & Equipment Auctions

23222 (A50323)
23222 (A50323)
PLEASE VIEW ALL PICTURES!! (A50775)
PLEASE VIEW ALL...
2015 Jeep Compass SUV (A50324)
2015 Jeep Compass...
2006 International 9400i (A53473)
2006 International...
1271 (A50490)
1271 (A50490)
2011 John Deere 5075 4WD Agricultural Tractor (A52377)
2011 John Deere...
 
Top