MossRoad
Super Moderator
- Joined
- Aug 31, 2001
- Messages
- 63,295
- Location
- South Bend, Indiana (near)
- Tractor
- Power Trac PT425 2001 Model Year
What's item #2 in that diagram?
Replacing another Wheel Motor.
- Thread starter Barryh
- Start date
- Views: 8114
What's item #2 in that diagram?
MossRoad
Super Moderator
- Joined
- Aug 31, 2001
- Messages
- 63,295
- Location
- South Bend, Indiana (near)
- Tractor
- Power Trac PT425 2001 Model Year
Gotcha. Thanks.
OP
Barryh
Veteran Member
- Joined
- Jul 5, 2005
- Messages
- 1,588
- Tractor
- Former owner of a P T -180 / Kubota BX-1500 .. A Craftsman Yard Tractor / John Deere 140 H-1 / Cub Cadet 108. And now ( Little Red ) a Power Trac 1425
PTO manifold ...
MossRoad
Super Moderator
- Joined
- Aug 31, 2001
- Messages
- 63,295
- Location
- South Bend, Indiana (near)
- Tractor
- Power Trac PT425 2001 Model Year
In the drive circuit?
OP
Barryh
Veteran Member
- Joined
- Jul 5, 2005
- Messages
- 1,588
- Tractor
- Former owner of a P T -180 / Kubota BX-1500 .. A Craftsman Yard Tractor / John Deere 140 H-1 / Cub Cadet 108. And now ( Little Red ) a Power Trac 1425
Sorry wrong diagram, was for an old PT-184... This would be for the my 1430 ...
Attachments
OP
Barryh
Veteran Member
- Joined
- Jul 5, 2005
- Messages
- 1,588
- Tractor
- Former owner of a P T -180 / Kubota BX-1500 .. A Craftsman Yard Tractor / John Deere 140 H-1 / Cub Cadet 108. And now ( Little Red ) a Power Trac 1425
Surprised no one called me out on this one either .. :laughing: Nice of you .. No I don’ have a 1430 but I do have a digrams for my 1425 .. At this point guess it does’t matter lol .. Guess I should stop rushing around before I post something.. Anyway will be ordering another wheel motor Next week thanks again for all the reply’s and insight..
MossRoad
Super Moderator
- Joined
- Aug 31, 2001
- Messages
- 63,295
- Location
- South Bend, Indiana (near)
- Tractor
- Power Trac PT425 2001 Model Year
1425, 1430....
220, 221, whatever it takes...
220, 221, whatever it takes...
OP
Barryh
Veteran Member
- Joined
- Jul 5, 2005
- Messages
- 1,588
- Tractor
- Former owner of a P T -180 / Kubota BX-1500 .. A Craftsman Yard Tractor / John Deere 140 H-1 / Cub Cadet 108. And now ( Little Red ) a Power Trac 1425
:laughing::confused2:
OP
Barryh
Veteran Member
- Joined
- Jul 5, 2005
- Messages
- 1,588
- Tractor
- Former owner of a P T -180 / Kubota BX-1500 .. A Craftsman Yard Tractor / John Deere 140 H-1 / Cub Cadet 108. And now ( Little Red ) a Power Trac 1425
OK replaced the other side wheel motor .. Man what a difference in the way she rolls vibration gone ... So now have replaced three the one remaining motor does not leak and seems fine for now..
Also if anyone here is planning on replacing more than one motor ..It would be worth your while to buy one of these 10 hydraulic pullers. This time for the heck of it .. I just sprayed on some PB blaster let it set for about 15 min's .. After the initial tighting of the puller .. I took two long strokes and it shot off like a rocket. Didn't have to use a hammer or a torch .. So much easier than the first one with a regular puller ..
Now to take off the gas tank, install new lines / petcock and heat shield. The one on the bottom of the steel tank is pretty cracked up.
Also if anyone here is planning on replacing more than one motor ..It would be worth your while to buy one of these 10 hydraulic pullers. This time for the heck of it .. I just sprayed on some PB blaster let it set for about 15 min's .. After the initial tighting of the puller .. I took two long strokes and it shot off like a rocket. Didn't have to use a hammer or a torch .. So much easier than the first one with a regular puller ..
Now to take off the gas tank, install new lines / petcock and heat shield. The one on the bottom of the steel tank is pretty cracked up.
Attachments
MossRoad
Super Moderator
- Joined
- Aug 31, 2001
- Messages
- 63,295
- Location
- South Bend, Indiana (near)
- Tractor
- Power Trac PT425 2001 Model Year
Is that a home-made bucket level indicator rod I see on your FEL?
