BigGary
Bronze Member
I removed the 448 hoe from my 4320 this week end and had a tuff time untill I discovered a trick that I don't think is covered in the removal instructions.
I went by the book but the lift arms would not lower enough to be able to drive out of the hoe.
I tried prying down and they would move down but would spring back up when the pressure of the pry bar was taken away.
After a time I thought of dialing down the raise - lower three point hitch speed control and that did the trick.
I hope this saves somone the trouble that I went through this week end.
I went by the book but the lift arms would not lower enough to be able to drive out of the hoe.
I tried prying down and they would move down but would spring back up when the pressure of the pry bar was taken away.
After a time I thought of dialing down the raise - lower three point hitch speed control and that did the trick.
I hope this saves somone the trouble that I went through this week end.
