Reaf blade mods, anyone?

[Charliebrn]

I wonder if anyone has modified a rear blade to change the angle on the rear blade without leaving the seat. I like the rear blade, but it's a pain to get off the tractor, change the angle and get going again. It would save a lot of time, and after all, I'm lazy when I can get away with it.... /w3tcompact/icons/smile.gif

 

[beenthere]

I have an older Deere blade that I can change the angle from the seat. It has a long lever that disengages a stop, which allows the blade to turn (this requires some planning so the pressure is on the blade at the correct place to turn it). Letting go of the lever engages the stop.

 

[rdbrumfield]

A couple of hyd cyls if you have the ports. I'm in the same boat as you, but a little exercise and fresh air is what I need.