Quick Attach Adapter Max 28

[mitchash]

Im looking for a quick attach adapter for my Max 28XL. I would keep my bucket pin on and use the adapter plate for a set of forks I have, also might get a snowplow. I have found a couple of universal ones. Anyone have any experience and recommendations? Thanks

 

[drajj5]

I Purchased this

2X Weld On Skid Steer Quick Attach Conversion Adapter Quick Tach Latch Box 73735335741 | eBay

I did have to buy a plate for the bucket as I cut off the (Original pin plate off the bucket and welded them to the kit purchased above

Cost was around 200 for the conversion

Regards
Don

 

[mike69440]

You will have very weak curl force with a QA on the Max.

 

[mitchash]

You will have very weak curl force with a QA on the Max.

Does the newer Max26 have the quick attach? Can that be adapted to the Max28?

 

[drajj5]

Does the newer Max26 have the quick attach? Can that be adapted to the Max28?

I am unsure if it can (however if you - just weld the original bucket tabs directly on to the adapter plate) you will not lose much of your bucket breakout force).

He is right that some breakout force it lost... but.... I upgraded my hydraulic bucket cylinders. Thanks To a fellow on here


The Modification that I made moved the bucket away from the pins buy only 1". I 'had' to have pallet forks installed.....as my son uses it frequently for Pallet handling

 

[mitchash]

I am unsure if it can (however if you - just weld the original bucket tabs directly on to the adapter plate) you will not lose much of your bucket breakout force).

He is right that some breakout force it lost... but.... I upgraded my hydraulic bucket cylinders. Thanks To a fellow on here


The Modification that I made moved the bucket away from the pins buy only 1". I 'had' to have pallet forks installed.....as my son uses it frequently for Pallet handling

Where did you get the upgraded bucket cylinders? Mine seem weak even with the stock set up.
Thanks

 

[drajj5]

The bucket cylinders were replaced with larger ones. Here is a link from the original Poster who came up with the idea! Good People!

Weak Loader Curl Possible Solution For the Max28


Just remember that this required cylinder modification... and parts must be "made" to ensure proper fitment.

 

[mitchash]

The bucket cylinders were replaced with larger ones. Here is a link from the original Poster who came up with the idea! Good People!

Weak Loader Curl Possible Solution For the Max28


Just remember that this required cylinder modification... and parts must be "made" to ensure proper fitment.

Thanks!