pulling bearing race out of roller tube for hesston bailer
- Thread starter kioskcarp
- Start date
- Views: 7060
5030
Rest in Peace
- Joined
- Feb 21, 2003
- Messages
- 28,967
- Location
- SE Michigan in the middle of nowhere
- Tractor
- Kubota M9000 HDCC3 M9000 HDC
Socket or pipe with a diameter just snaller than the ID of the tube the bearing is in.
Tx Jim
New Member
Ditto on welding bead around center of race to shrink it.
jaotguy
Veteran Member
to make a puller ....
a long steel pipe thinner than the bearing race ....
a bigger shorter pipe that just slips over the smaller pipe
an end cap for the smaller pipe ...
a grade 8 nut and bolt just longer than the pipe is wide
drill a hole across the end of the pipe , slip the bolt through and put the nut on......
now put the nut/ bolt end down , slide the shorter larger diameter pipe on to the smaller pipe , then screw on the end cap to the smaller pipe
slide the small pipe into and hook the nut or bolt behind the race lip ....
you now have a slide hammer to pull the bearing race ... tap a few times , move the but/bolt to the opposite side of the bearing and tap and repeat .. do not try to pull it out from just one side , the race will twist and jam ....
a long steel pipe thinner than the bearing race ....
a bigger shorter pipe that just slips over the smaller pipe
an end cap for the smaller pipe ...
a grade 8 nut and bolt just longer than the pipe is wide
drill a hole across the end of the pipe , slip the bolt through and put the nut on......
now put the nut/ bolt end down , slide the shorter larger diameter pipe on to the smaller pipe , then screw on the end cap to the smaller pipe
slide the small pipe into and hook the nut or bolt behind the race lip ....
you now have a slide hammer to pull the bearing race ... tap a few times , move the but/bolt to the opposite side of the bearing and tap and repeat .. do not try to pull it out from just one side , the race will twist and jam ....
