Pulley / PTO Shaft

[alvanko]

I am in need of a pully for an old chipper I have.
Pulley is 16" diameter with a 1" center hole and 1/4" key way. 5/8" v-belt. I have searched ww grainger and the closest I can find is 14". Mine is steel. Would like to keep the same or cast, would like to stay away from aluminum. It needs to have set screws.
.
I am also in need of a PTO shaft or half of a PTO shaft. 27" (approx) overall. 1" round center in the yoke with 1/4" key way, standard 1 3/8" 6 spline on the other end.
I have half of a shaft that is hollow triangular tubing approximately 1" diameter with the 1" round yoke with key way. I would need the other end that slips over this with the 1 3/8" six spline yoke.
Any sources I can search?

 

[barneyrb]

I'd go to your local power transmission house (Motion Industries, Dixie Bearing) They can fix you up with a Browning or Dodge. It looks like there are about 12 located in Ohio

 

[Inspector507]

alvanko,
If I remember correctly, the chipper shredder was made by MacKissic. You might try to contact them here.