Scotty370
Platinum Member
- Joined
- Dec 18, 2008
- Messages
- 896
- Location
- Buffalo, New York
- Tractor
- 318 John Deere, 4200 John Deere, 1947 John Deere "M"
In my build, I've reached a dilemma. I don't know, nor can I find good PTO driveshaft info. About as far as I've gotten is that the measurements appear to be between the yoke pins when retracted. The working range is sketchy at best! It appears that 10" is the norm, but longer shafts obviously must give you more than that. Also, nowhere can I find acceptable deflection angles at the yokes. Also can't find dimensions on, yoke pin to end of collar, or good measurements on slip-clutches. Thought I'd break this out of my original thread to reach a larger audiance! Thanks in advance! ~Scotty
