3-Point Hitch PTO RPM question

   / PTO RPM question #21  
Piloon, especially with wet snow. Bob
 
   / PTO RPM question #22  
ismilelots - when you get it figured out and have used the pto driven implement a few times. Your ear will tell you when you have reached the correct rpm. Besides, as previously mentioned, unless it's a generator - a little higher or lower won't make much difference.
 
   / PTO RPM question
  • Thread Starter
#23  
ismilelots - when you get it figured out and have used the pto driven implement a few times. Your ear will tell you when you have reached the correct rpm. Besides, as previously mentioned, unless it's a generator - a little higher or lower won't make much difference.

Thank you. I was concerned that the brush hog and tiller wouldn't work well if not at the recommended RPM. It's good to know there is some wiggle room.
 
   / PTO RPM question #24  
I run my rotary cutter about 2 hundred Engine RPM below 540 pto speed, works fine for me.
 

Tractor & Equipment Auctions

Amco J16 10'Disc Harrow (A53314)
Amco J16 10'Disc...
2016 Chevrolet Malibu Sedan (A53424)
2016 Chevrolet...
3pt 3-Bottom Mold Board Plow (A53316)
3pt 3-Bottom Mold...
2003 Walk-Behind Automatic Seed Spreader (A55851)
2003 Walk-Behind...
6" Jaeger Pump (A53314)
6" Jaeger Pump...
Skid Of Metal T Posts (A50775)
Skid Of Metal T...
 
Top