SpringHollow
Elite Member
My 1850 has the Deutz filter housing.
m5040
Veteran Member
- Joined
- Nov 23, 2008
- Messages
- 1,024
- Location
- CT
- Tractor
- Kubota M6040 L2250, JohnDeere 310D, Ford 841 Elenco, Ford 961, Trapmaster, PT180 w/LM bucket and 45" brush cutter, PT1430 Deutz w/grapple bucket, Antonio Carraro Tigrecar 6500. John Deere 5300. Former owned Steiner 430 max, Goldoni REV Maxter 7
You should not have a scenario where you have to open the intake ductwork to lift the hood. Every time you do, some amount of dirt inevitably will enter the engine.
MossRoad
Super Moderator
- Joined
- Aug 31, 2001
- Messages
- 66,387
- Location
- South Bend, Indiana (near)
- Tractor
- Power Trac PT425 2001 Model Year
Be creative....
Do a reverse gull wing engine cover that splits down the middle and drops to the sides. Each half would be a lot easier to handle than the whole is now. You'd have to figure some mounts for fans, coolers, etc., perhaps, but a lot of you guys are pretty creative and industrious.
I'd be happy to watch you do it.
Do a reverse gull wing engine cover that splits down the middle and drops to the sides. Each half would be a lot easier to handle than the whole is now. You'd have to figure some mounts for fans, coolers, etc., perhaps, but a lot of you guys are pretty creative and industrious.
I'd be happy to watch you do it.
m5040
Veteran Member
- Joined
- Nov 23, 2008
- Messages
- 1,024
- Location
- CT
- Tractor
- Kubota M6040 L2250, JohnDeere 310D, Ford 841 Elenco, Ford 961, Trapmaster, PT180 w/LM bucket and 45" brush cutter, PT1430 Deutz w/grapple bucket, Antonio Carraro Tigrecar 6500. John Deere 5300. Former owned Steiner 430 max, Goldoni REV Maxter 7
When we were kids and it didn't fit, add a hood scoop or a shaker hood!
