I have a Husqvarna YTH22V46 with a Tuff Torq K46 transmission. It was due for a rebuild which I did. After sealing and filling with fluid I tested the transmission on the bench with a drill. One of the axles turns fine in forward and reverse. The other axle begins turning in both directions but slowly stop after a few seconds. The process repeats every time I start/stop the drill. For the life of me I can't imagine what's causing this. Any ideas very much appreciated. Thanks
Problem after Tuff Torq rebuild
- Thread starter Mtab
- Start date
- Views: 1181
Richard001
Veteran Member
Welcome to TBN 
Sorry, I can't help you with that, I'm someone will pop in here and help you out.
Sorry, I can't help you with that, I'm someone will pop in here and help you out.
RandyT
Elite Member
This was answered by myself on another forum. The answer is due to the differential one axle is dragging slightly more than the other therefore transferring all the axle rotation to the easier to spin axle.
