SCWOOD
Silver Member
Where to get a gauge? Do you buy the gauge and the fittings? I want to connect to the loader disconnect. Where to get the male fitting? Thanks!
pressure gauge to check hydraulic pressure on Kioti CK2510
- Thread starter SCWOOD
- Start date
- Views: 3904
-
- Tags
- kioti ck2510
WranglerX
Super Member
Might look here.... Go to this pager and scroll down some.... And yes it's ok to disconnect one of you FEL hoses and place gauge in place of hose and dead head the gauge long enough to get reading..... How you adjust relief pressure should be in your tractors shop manual....
www.boltonhooks.com
Hydraulic Tools - BoltOnHooks LLC
Bolt-On Hooks and Hydraulic Tools for compact tractors.
www.boltonhooks.com
Tinhack
Elite Member
- Joined
- Jul 3, 2020
- Messages
- 3,105
- Location
- Lytle, TX
- Tractor
- Ford 3910, John Deere 420C, Kubota G32XKS, IH 2606, Bad Boy Maverick-60"
I can't see it from here. Take it off and measure it.
Forgot to add: Make sure you get a gauge with the expected pressure in the middle of the range of the gauge. If you expect 2000psi, get a 4000psi gauge. It will be more accurate as well as safer.
Last edited:
Buggs67
Veteran Member
This is great. They have charts and PDFs to match up your Quick Connector. I asked my dealer to check all my pressures while he was fixing the BH joysticks and rebuilding an FEL cylinder but I don't believe he did.Might look here.... Go to this pager and scroll down some.... And yes it's ok to disconnect one of you FEL hoses and place gauge in place of hose and dead head the gauge long enough to get reading..... How you adjust relief pressure should be in your tractors shop manual....
Hydraulic Tools - BoltOnHooks LLC
Bolt-On Hooks and Hydraulic Tools for compact tractors.
