PLEASE HELP!!!!

[TractorFiend]

Hi I recently purchased a Mitsubishi 1800D Tractor 2WD. When i got it, it was working fine. Eventually the lift stoped working to full potential IE. It would hardly lift my small grador Box. So i finally figured out it was the O-Rings in the pump. I replaced them and after 3 weeks they have alredy gone bad again!!! /forums/images/graemlins/confused.gif I was wondering how to fix this problem and also where to get a seal kit.

Thanks Alot,
Forrest

 

[ns_in_tex]

Is there a Crown Products in your area. I have one near me & if I carry in my old Orings & seals, they can normally match.

 

[Slamfire]

Dirt in the hydraulics? /forums/images/graemlins/confused.gif

 

[markie61]

I remember reading that a nick, cut, or scratch on the rod can cut the seals. Extend the rod out of the cylinder and inspect for damage.
Mark

 

[TractorFiend]

thanks guys i'll check this stuff

 

[HayDR]

Use the Vitom high temp. O-Rings