3-Point Hitch Please - a measurement on Class III Boomers

   / Please - a measurement on Class III Boomers #1  

DocHeb

Veteran Member
Joined
May 24, 2001
Messages
2,340
Location
Michigan
Tractor
New Holland TC40D Supersteer
I am not at my tractor and I need a measurement for a Class III TC34/40/45.

What is the height (approximately to the center of the hole) of the lower arms of the three point when they at their lowest position?
 
   / Please - a measurement on Class III Boomers #2  
Chris, do you mean at the hitch balls? I'm away from my tractor right now too, but I'm sure the hitch ball will lower to around 6" off the ground. I do have TnT and that probably puts me a bit lower than some.
 
   / Please - a measurement on Class III Boomers
  • Thread Starter
#3  
Yes, at the center hole of the lower arm hitch balls
 
   / Please - a measurement on Class III Boomers #4  
Chris

Measured to the center of the 3pt lift arm ball hole on the non adjusting side (left) on a flat concrete floor 7".

I have a 2003 TC45DA with loaded R-4 17.5L-24

Jack
 
   / Please - a measurement on Class III Boomers
  • Thread Starter
#5  
Measured to the center of the 3pt lift arm ball hole on the non adjusting side (left) on a flat concrete floor 7".

I have a 2003 TC45DA with loaded R-4 17.5L-24

Thanks, I have R-4s also. That was about my recollection, and I will design a little lee-way in. Thanks
 

Tractor & Equipment Auctions

(3) Piece Harrow (A50515)
(3) Piece Harrow...
New Holland 477 Swather/Mower Conditioner (A52128)
New Holland 477...
2011 Ford F-550 Iowa 1015 3,200LB Crane Mechanics Truck (A51692)
2011 Ford F-550...
2016 Ford Explorer AWD SUV (A50324)
2016 Ford Explorer...
1992 TIFF Motorhome (A50324)
1992 TIFF...
NISSAN MU1F2A25LV WAREHOUSE FORKLIFT (A51243)
NISSAN MU1F2A25LV...
 
Top