Dirt Moving PHD on front

[woody]

Tom H.
Thanks for the reply, the specs on my B26 is 11.2 gpm and I have come up with a way to mount it to the middle of my bucket and if that does not work I have have a quick connect bucket so I can remove the bucket if I have to. so I need to figure out what hyd. motor I will need and get the part number for the remote to put on the tractor. thanks again

 

[ultrarunner]

The local Kubota Dealer said he had set up b26's with a backhoe mounted Hydraulic Post Hole Digger for a local landscape company...

Made it easier to reach hard to get to places and the thumb hydraulics were used to power the auger.

 

[woody]

had not thought of that, that is why I like this site. great idea got me to thinking now. yea I know I'm going to have a headache

 

[ultrarunner]

Here's a picture I found here at TBN

http://www.tractorbynet.com/forums/...ger-hydraulics-5-27308-augeronbackhoeside.jpg

 

[radman1]

Ultrarunner

Good point about the PHD on the hoe. A hydraulic PHD mounted in the middle does not let you see the tip when setting it down. I still think 11 gpm is marginal to run a hydraulic PHD. What is the hydraulic psi of a B26?

 

[RobertN]

These guys have an entry level auger; 15-25gpm recomended
Woods Equipment Company - AUGERS: Alitec HA-series for skid steers

 

[ultrarunner]

Here's one more that need at least 5 gpm

Worksaver Hydraulic Post Hole Diggers

I read somewhere the b26 has 11gpm with 7 available for the backhoe.

 

[woody]

Radman1, the psi is 2250 to 2400. I like the idea of putting it on the backhoe since that would save dollars and I would not have to add a new valve.