Permanently Pinned

   / Permanently Pinned #1  

kieramax

New member
Joined
Aug 3, 2013
Messages
7
Location
Port Alberni BC Can.
Tractor
Kubota B20
I am new here and I need a bit of help. I am trying to replace the main swing pins on my BT 750. I have removed the Allen set screws and given it a few good wacks but it won't budge , Do I need to use a porta power or is there a secret trick. I have the new pins and there does not seem to be anything else to keep them from comming out. Thanks in advance.:(
 
   / Permanently Pinned #2  
I just went through this with my backhoe ( different brand). After hours of messing with it using several methods, I was finally able to get it out with a large hammer and 1" drift. My next move was to use a hydraulic cylinder w/ cross tube cut off and try that...... If I owned a porta power, it would have been used after my first attempt to remove it after the initial hammer and drift failed to work..
 
   / Permanently Pinned
  • Thread Starter
#3  
Thanks for the info. I have access to a porta power but was leary of going to that level. thanks again
 

Tractor & Equipment Auctions

2003 JOHN DEERE 350D OFF ROAD DUMP (A51242)
2003 JOHN DEERE...
2006 Magnolia Dry Fertilizer Tender Trailer - Dual Stainless Compartments, Hydraulic Doors (A51039)
2006 Magnolia Dry...
2011 Liebherr L586 (A51039)
2011 Liebherr L586...
2019 Allmand Night-Lite V-Series S/A Towable Light Tower (A49461)
2019 Allmand...
(INOPERABLE) CAT D4D (A50854)
(INOPERABLE) CAT...
2014 MultiQuip WhisperWatt 40kW Three-Phase Diesel Generator (A49461)
2014 MultiQuip...
 
Top