TheeKb
Member
Man great job 
Looks super efficient and sharp too! Thx for the info/instruction.
Looks super efficient and sharp too! Thx for the info/instruction.Pallet Fork Mods
- Thread starter prosparky
- Start date
- Views: 13015
oldballs
Elite Member
- Joined
- Dec 29, 2009
- Messages
- 4,534
- Location
- Kansas...USA
- Tractor
- Kubota B2620 , Case 448 , Kubota B2650
How about those "great minds" thinking alike.
oldballs
Elite Member
- Joined
- Dec 29, 2009
- Messages
- 4,534
- Location
- Kansas...USA
- Tractor
- Kubota B2620 , Case 448 , Kubota B2650
The best I recall, it was hand scraped last fall and sprayed with Fluid Film. But the blades were not changed until this unusually warm February.
I keep a clean set of cups and washers along with a sharpened set of blades ready to go each Spring. This MMM is on it's 5th season. It was hand sanded and repainted once a couple years ago. Never have used a pressure wash on it.
Cheers,
Mike
On second though, it looks like it was put away dirty....and the "clean" picture was after i serviced it. Looks like it took me about 4 hours to get 'er done.
I keep a clean set of cups and washers along with a sharpened set of blades ready to go each Spring. This MMM is on it's 5th season. It was hand sanded and repainted once a couple years ago. Never have used a pressure wash on it.
Cheers,
Mike
On second though, it looks like it was put away dirty....and the "clean" picture was after i serviced it. Looks like it took me about 4 hours to get 'er done.
