Harry in Ky
Veteran Member
Many systems do it that way with no problems.
Older CK25Hst stop solenoid.
- Thread starter Desert Moose
- Start date
- Views: 506
-
- Tags
- solenoid stop solenoid
OP
Desert Moose
Member
I might try it. would be easy to do, just add a jumper wire once I find the right wire to connect to.
Harry in Ky
Veteran Member
Depending on how the starter is made you may not need to "find a wire". You can "double up" on the signal wire to starter, or maybe if it has a two post solenoid attach a wire to bottom post that sends power into the motor brushes. I've seen it done that way.
OP
Desert Moose
Member
OK, without a wiring diagram, I'll just have to look and find what's the best approach. Thanks for the ideas.
perrypower
Silver Member
You need the 2 pin to 3 pin conversion harness: Kioti Engine Stop Solenoid 2 Pin Conversion Harness - Nolt’s Power Equipment
OP
Desert Moose
Member
Well, the new timing relay didn't fix it. I'm thinking there's some corrosion in a connector or something cutting down the voltage to the solenoid. Without a wiring and connector location diagram, I don't know where the involved connectors are. Recent shoulder surgery prevents me from crawling under and blindly poking around, so I did the bypass I talked about, Installed a push button connected to power and the pull in wire. It works great, turn the key on, bump the new button, the solenoid snaps in, and then start as normal. Not a true repair, but it works fine. Thanks everyone for all the info.
Harry in Ky
Veteran Member
I'm always in favor of a creative workaround to help beat the system. Been there, done that, more times than I care to count.
