Oil plug on 5093E oddball

[beenthere]

For a plug wrench, maybe a short length of square stock that fits, and then use an adjustable wrench (crescent) to turn it out and back in.

 

[Lineman North Florida]

Should have a couple zerks on the trunnion, a few on the 3 point hitch links, and two on the rear axle bearings..

Are there other places that you think should have them?

I found the 1 on each side for the axle bearings and I found the 3 on the 3 point hitch arms but what I didn't find was any on the ball joints or steering links or whatever you want to call the front end components, it's all sealed, my other tractor has greaseable front end components everywhere, so yeah, I felt like there was other places that I should have found them.

 

[Tx Jim]

Well, if you had a 4020...you'd get to buy a John Deere Steering Valve Adusting Tool...

Except it takes a lot more mechanical ability & knowledge to correctly utilize the 4020 steering valve adjusting tool than it requires to change engine oil.

 

[beenthere]

I found the 1 on each side for the axle bearings and I found the 3 on the 3 point hitch arms but what I didn't find was any on the ball joints or steering links or whatever you want to call the front end components, it's all sealed, my other tractor has greaseable front end components everywhere, so yeah, I felt like there was other places that I should have found them.

There are two on the front axle (called trunnion in operators manual). Key item #7

 

[Lineman North Florida]

There are two on the front axle (called trunnion in operators manual). Key item #7

Thanks, I will check on those tonight when I get home.