NX series Power Beyond Port

[JimR]

Does the NX series tractors have a Power Beyond Port, if so, where? I am considering installing a valve for a grapple bucket setup + plow pistons. TIA for any help. I know Kioti sells a kit for $1250.00.

 

[countrybumpkin]

Yes it does, it's on the back of the loader valve , I believe it's the same on a open station as the cab version. It is the line with the banjo bolt fittings that runs from the loader valve to the rear of the tractor were the rear remotes are located. You'll have to have adapters to replace the banjo bolts with so you can new hoses to your new valve.

 

[JimR]

Yes it does, it's on the back of the loader valve , I believe it's the same on a open station as the cab version. It is the line with the banjo bolt fittings that runs from the loader valve to the rear of the tractor were the rear remotes are located. You'll have to have adapters to replace the banjo bolts with so you can new hoses to your new valve.

Thanks for the information. I will check that out once the snow stops flying around here. It is a "next summer project" for me to add the forward hydraulics on my tractor's loader for a grapple or possible angle snow plow setup.

 

[N2DFire]

Check out EricTheOrical's reply in this thread for some information on the 3rd function install on his NX. Pretty nice work.
http://www.tractorbynet.com/forums/kioti-owning-operating/356319-third-function.html

 

[JimR]

Check out EricTheOrical's reply in this thread for some information on the 3rd function install on his NX. Pretty nice work.
http://www.tractorbynet.com/forums/kioti-owning-operating/356319-third-function.html

Thnaks for the link. I posted a message to him. That was a very nice job that he did on his tractor.