3-Point Hitch No lift in 3-point hitch

   / No lift in 3-point hitch
  • Thread Starter
#61  
I think thats the answer. And if so, that sucks. IF they adjusted the 3PH valve too far, its position becomes totally dynamic and dependent on pressure. Makes for a smooth operating hitch, but anything else that changes pressure in the system changes pressure in that circuit and you see movement as a result.

I guess first think I would do is try to replicate the issue. Raise the hitch up, an keep an eye on it while you do some maneuvers with the FEL. Pushing into something, dumping, raising, etc. Just put it through its paces

:thumbsup: Hi Guys!! It's been a rough couple weeks. I'm sorry didn't get back to y'all sooner! I've spent 2 days and evenings stripping my barn and putting back 650 pounds of fresh straw for bedding/soaking up all the darn water. Short story is, I ended up with sciatica. Hard for me to even sit long enough to read your excellent responses. Anyway, that first adjustment (http://www.tractorbynet.com/forums/...ift-3-point-hitch-img_20150307_233526_966-jpg) you all suggested helped me get a bale back to the cows without having to push it backwards on the ground. Many, many thanks! I have to goose the FEL to get the lift, but at this point, I am grateful.

I send a picture to show you! 20150318_183125.jpg

As far as putting the tractor through its paces, I have to wait on that until things dry out... ... ... ... In the mean-time, I finally broke down and scheduled a visit with my chiropractor... Thank you again!!!
 
   / No lift in 3-point hitch #62  
Next thing you could do is check what PSI your tractor has (and bump it up some ;)) Usually, dealers set it around 2250 and the manual (I think) calls for 2475? I was able to just tighten my nut to get an extra 150# of lift - planning to bump it up again to 2600 PSI. Make sure you have a gauge to know the before and after PSI. You can damage the pump...

http://www.tractorbynet.com/forums/...343772216-bump-up-lift-capacity-l3400-002-jpg

http://www.tractorbynet.com/forums/...ctions-add-extra-spools-l2800-tighten-nut-jpg
 
   / No lift in 3-point hitch #63  
Pictures of feeding bales in Alberta. Thought it might be interesting.image.jpgimage.jpgimage.jpgimage.jpg

The ipad ! Upside down
 
   / No lift in 3-point hitch
  • Thread Starter
#64  
Thank you teg and Egon! Excellent pictures! Back is doing better, but I still do "too much..." :rolleyes:
 

Tractor & Equipment Auctions

GRID SHAPED BUCKET FOR MINI EXCAVATOR (A58214)
GRID SHAPED BUCKET...
2022 Horizon Trailer (A55973)
2022 Horizon...
Brock Meyer 2000S 70'x12' 2000 BPH Grain Dryer (A57148)
Brock Meyer 2000S...
2012 TEX MEX TRAILER LOW BOY GOOSENECK (A58214)
2012 TEX MEX...
2000 INTERNATIONAL 4900 CAR HAULER (A58018)
2000 INTERNATIONAL...
2003 Big Tex 10PI 16ft. T/A Pipe Top Utility Trailer (A55973)
2003 Big Tex 10PI...
 
Top