Hi all I'm considering a TC35DA hst with about 589 hrs asking $15k. I'm hoping to get them down to $13,500/$14k. My question is this. They have a boomer 250tl loader on it which when I look at the specs has a good bit more capability than the loader that normally comes with the TC35DA..will this loader they have on it still perform up to its specs even though it's not on the boomer tractor it was designed for?
NH TC35da
- Thread starter JMER
- Start date
- Views: 1110
Sysop
Elite Member
- Joined
- Jun 7, 2013
- Messages
- 3,301
- Location
- Fairmont, WV
- Tractor
- Mahindra 4035HST purchased 2013 - Husqvarna TS348-D purchased 2019 - Craftsman 42" HST purchased 2003
It may not operate up to the rated speeds; time to lift full load to max height, full curl to full dump time, etc... It will still lift the full weight capacities, just not as quickly if the hydraulic flow (GPM) is less. Also, if the tractor it was made for is a different height, there will be a difference in the overall lift height as well.
WM75Guy
Elite Member
It is the correct loader. At the time the 16LA loader was used on the TC35/40/45 series. The 16LA is no longer available. The 250TL is the model that replaced the 16LA. It has 200# more lifting capacity, 1800# vs 2000#, but that should not be an issue with operating the tractor or loader. On the brighter side parts availability should not be an issue.
