NH TC30 hydraulic hook-up for 110TL/7308 loader

   / NH TC30 hydraulic hook-up for 110TL/7308 loader #1  

Famdoc2892

New member
Joined
Jun 29, 2025
Messages
3
Tractor
New Holland TC30
Good evening! “Recycling” a 7308 loader previously mounted on a TC29 tractor, had hydraulic hoses made to replace the hard lines from pump/diverter to the valve. I️ have those lines connected to the P, PB and T ports of the 2-spool valve. The work ports are labeled A1/A2, B1/B2. My dilemma in connecting to the loader lines is that, with joystick vertical, A1 and A2 are located horizontally left and right from each other at the top, and B1/B2 are horizontally opposed at the bottom of the valve. Should lines from one cylinder set still be connected to A1/A2 as a control set, or A1/B1 which are vertical to each other?
 

Attachments

  • IMG_4875.png
    IMG_4875.png
    957.3 KB · Views: 24
   / NH TC30 hydraulic hook-up for 110TL/7308 loader #2  
A1 and b1. I suspect the number correlates to the spool. And the letter the port. If not..just swap hoses.

You want the cylinder to be on the same spool. Thus it can open both ports. One port to pressurize and one to take fluid.
 
   / NH TC30 hydraulic hook-up for 110TL/7308 loader
  • Thread Starter
#3  
Thanks for the response. You are absolutely correct, I️ tried it yesterday evening and I️ have a functioning loader! Many thanks!
 

Tractor & Equipment Auctions

(9) 2 PLUG VALVES 1502 IRON (A52472)
(9) 2 PLUG VALVES...
2009 Freightliner M2 106 MedTec Ambulance (A51692)
2009 Freightliner...
2010 Ford Edge SE SUV (A51694)
2010 Ford Edge SE...
2015 John Deere Z950M 70in Zero Turn Mower (A51691)
2015 John Deere...
MASSEY FERGUSON 492 TRACTOR (A51406)
MASSEY FERGUSON...
2011 KENWORTH T800 (A52472)
2011 KENWORTH T800...
 
Top