Newbie needs help

   / Newbie needs help #1  

jerrywtrull

New member
Joined
Jun 16, 2014
Messages
5
Location
Moultrie, Ga
Tractor
63 Ford 4000 4 cyl diesel
I have a ford 4000 4 cyl diesel tractor( not sure about the year) that was running fine. I was mowing for 3 hrs and parked it for the night and it has never started again. It acts like it is not getting any fuel.
Any ideas?
 
   / Newbie needs help #2  
Welcome from Wisconsin there are Experts on fords here they will be helping you.
 
   / Newbie needs help #3  
Jerry...check your fuel filter...it well could be clogged...from what you say I guess it is turning over but just won't crank...Fuel filter is the first thing I would check...Others will have advice...stay tuned...Welcome...
 
   / Newbie needs help
  • Thread Starter
#4  
Thanks for such a quick response, I have replaced the fuel filter, also I am getting fuel to the injector pump but none to the injectors. Is it possible the injector pump went out so easy? It does not have a stop cable, you just push the throttle lever all the way up to shut off.
 
   / Newbie needs help #5  
Is it making any smoke as you crank it?
 
   / Newbie needs help
  • Thread Starter
#6  
no smoke, the engine just turns over. I even tried a small amount of starting fluid and no results. I had a guy tell me there may be a throttle needle stuck in the injector pump, is that possible?
 
   / Newbie needs help #7  
gov ring may be bad.. ..

try getting a pull start for the heck of it though.. it may just have not bleed yet. them roosamaster bleed hard I hear.
 
   / Newbie needs help #8  
My old MF30 diesel backhoe used to require a squirt of starting fluid every time. Had to carry a can in the toolbox. Maybe try a squirt in the air cleaner, can't hurt.
 
   / Newbie needs help
  • Thread Starter
#9  
Thanks guys for your input but nothing works. I pulled it around for a while and it did not even try. I tried more starting fluid and it does not even try to start. I has compression and is in time. I am out of ideas.
 
   / Newbie needs help #10  
you say it has compression... yet does not even 'try' on start fluid.

I got news for you. if it does not pop on start fluid. it either has stuck intake valves , blocked air intake, or no compression ( too low of compression for heat of combustion to occur )
 

Tractor & Equipment Auctions

2009 FREIGHTLINER BUSINESS CLASS M2 CRANE/POLE TRUCK (A51406)
2009 FREIGHTLINER...
2025 SDLANCH IRGC40 UNUSED Electric Tricycle (A53117)
2025 SDLANCH...
2007 INTERNATIONAL 7400 DT466 SFA 4X4X CHASSIS TRK (A51406)
2007 INTERNATIONAL...
3 pallets of lockers (A53117)
3 pallets of...
1996 JLG Commander CM2033 20ft Electric Scissor Lift (A54811)
1996 JLG Commander...
2010 Ford Edge SE SUV (A51694)
2010 Ford Edge SE...
 
Top