new member

/ new member #1  

jage

New member
Joined
Jan 24, 2013
Messages
2
Location
ft. mohave, az
Tractor
yanmar 3810d
Howdy. Just joined. Getting ready to r&r a yanmar 3810d that I bought a few years back. Looking forward to help from friendly forum folks and hope to be able to contribute as well. Thank you.

Jage
 
/ new member
  • Thread Starter
#3  
Thx. Bob. Can't remember exactly when we got the tractor. Just brought it back from Silver Springs, NV. yesterday. Dad had it on his little 5 acre place and has been running it pretty solid for several years. I'm going to start with a serious powerwash and go one leak at a time. First, worst problem is where the trans bolts to the housing that also bolts to the motor. Serious hydraulic leak on the left side like a bad gasket that almost shoots out under power in reverse. I'm going to need a manuel and probably a ton of help before its over. This forum was my first stop from Google, so I'm sure there's a ton more I can research before I bomb everybody with dumb questions. Take Care.

Jage
 
/ new member #6  
:welcome:
 

Marketplace Items

WoodMaxx MX 9900 with almost no use
WoodMaxx MX 9900...
Informational Lot - Financing (A63688)
Informational Lot...
2016 Chevrolet Silverado1500 Pickup Truck, VIN # 1GCRCNEH4GZ236800 (A61165)
2016 Chevrolet...
Arrow Quip MAN-STBR Sternum Bar (A64047)
Arrow Quip...
UNUSED RAYTREE RMSG29 - 29" HYD STUMP GRINDER (A62131)
UNUSED RAYTREE...
1999 Ford F-150 4x4 Pickup Truck (A59230)
1999 Ford F-150...
 
Top