new member

/ new member #1  

jage

New member
Joined
Jan 24, 2013
Messages
2
Location
ft. mohave, az
Tractor
yanmar 3810d
Howdy. Just joined. Getting ready to r&r a yanmar 3810d that I bought a few years back. Looking forward to help from friendly forum folks and hope to be able to contribute as well. Thank you.

Jage
 
/ new member
  • Thread Starter
#3  
Thx. Bob. Can't remember exactly when we got the tractor. Just brought it back from Silver Springs, NV. yesterday. Dad had it on his little 5 acre place and has been running it pretty solid for several years. I'm going to start with a serious powerwash and go one leak at a time. First, worst problem is where the trans bolts to the housing that also bolts to the motor. Serious hydraulic leak on the left side like a bad gasket that almost shoots out under power in reverse. I'm going to need a manuel and probably a ton of help before its over. This forum was my first stop from Google, so I'm sure there's a ton more I can research before I bomb everybody with dumb questions. Take Care.

Jage
 
/ new member #6  
:welcome:
 

Marketplace Items

10ft Cattle Panels (A64047)
10ft Cattle Panels...
LOOK! (A63109)
LOOK! (A63109)
2019 Lynco Mini Mover Aircraft Tug Cart (A61567)
2019 Lynco Mini...
INOP/NON-RUNNING 2015 International DuraStar 4300 Lab/Chassis Truck, VIN # 3HAMMAAL3FL514548 (A61165)
INOP/NON-RUNNING...
2007 Ford Crown Victoria Passenger Car, VIN # 2FAFP73V67X124782 (A61165)
2007 Ford Crown...
Pat's QH and hydraulic top-link.
Pat's QH and...
 
Top