kayssupply
Platinum Member
The 1712 is hydraulic. The N uses two. I used the old stand by NAPA 1334. But a 1344 or 1348 will fit. Post a picture when you get it ready to go.
New Iseki TA210
- Thread starter IsekiManTA210
- Start date
- Views: 12645
htiek126
Silver Member
- Joined
- Mar 11, 2002
- Messages
- 236
- Location
- Southern Maryland
- Tractor
- Iseki TA270F, Yanmar YM1510D, Mitsubishi MT2201D
Kaysupply,
Looks like you are correct... I emailed Baldwin, received the following reply.... oh well, better to be stuck with a filter than damage the Hydraulics... Thanks....
"Thank you for using Baldwin Filters. I do not recommend the use of the BT260-10 in place of the BT260. The BT260-10 is six micron nominal, while the BT260 is 26 micron nominal. If you have further questions, please feel free to contact
me.
Thanks,
TRAVIS R. WINBERG
Service Engineering Supervisor
Looks like you are correct... I emailed Baldwin, received the following reply.... oh well, better to be stuck with a filter than damage the Hydraulics... Thanks....
"Thank you for using Baldwin Filters. I do not recommend the use of the BT260-10 in place of the BT260. The BT260-10 is six micron nominal, while the BT260 is 26 micron nominal. If you have further questions, please feel free to contact
me.
Thanks,
TRAVIS R. WINBERG
Service Engineering Supervisor
kayssupply
Platinum Member
You can see one hyd. filter just above the step. The other is under the fender/ seat. That appears to be the same size as the N239 I had. It is a nice tractor. The push button 4x4 is handy.
rstone
New member
I have a TA262 and have found a used bushhog loader (2246 QT) I can't afford the new mounts. Where can I find some? Also, how do I tap into the hydraulics?
