Grapple New grapple and toothbar
- Thread starter rfmr
- Start date
- Views: 2023
roxynoodle
Veteran Member
That's a nice looking setup you have there! If it were me, I'd be afraid to use it, it looks so good! Bet you have a lot of fun with that.
dieselsmoke1
Platinum Member
Sweet!!!
Looks like a rugged piece. Have fun!!!
Looks like a rugged piece. Have fun!!!
According to ATI specs, the grapple is 137 lbs and the toothbar is 47 lbs. Both are bolted on so they can be removed (Grapple - 4 bolts each side, Toothbar - 1 bolt each side). Grapple has seperate lever control tapped into and mounted beside the hydraulic control for the bucket. Hoses are quick disconnect.
3RRL
Super Member
- Joined
- Oct 20, 2005
- Messages
- 6,931
- Tractor
- 55HP 4WD KAMA 554 and 4 x 4 Jinma 284
That sounds like a great set-up.
You should be very happy with it. I don't have the grapple yet (in transit as we speak) but I've had the toothbar for quite a while and it's made a huge difference in digging and moving/popping brush and small trees.
You should be very happy with it. I don't have the grapple yet (in transit as we speak) but I've had the toothbar for quite a while and it's made a huge difference in digging and moving/popping brush and small trees.
PineRidge
Super Member
rfmr said:
Very nice looking setup. I also believe that if you look closer at your setup you can most likely pull the pins holding the cylinder and the lift arms and quickly pull them leaving the support tube on the bucket. I do it whenever I'm working in the dirt, it's quick and easy 5 minutes tops.
