need measurement off a 318

[bruce1963]

Hope someone can help.I have a 1988 318 thats been repowered with briggs vanguard and it flips the pto belt.I believe the motor is to far back,can anyone give me a measurement from center of pto pulley to the vertical part of the frame where the motor bolts.I am talking the part that bends up about 2 inches in front of motor.Thanks.

 

[radios1]

the measurement is not important, what really matters is the belt alignment!. both pulleys need to align with each other, you should be able to measure that with a square, if not, then take measuring points to something original, to each pulley, make sure you have the same distance to that on each pulley.. if you could post a side picture of the engine pulley/PTO pulley, I should be able to tell you what happened..

 

[JD Bob]

I have 316/318 parts available near Saratoga Springs, NY. Parted out 4 tractors, lots of odd ball stuff. Best to call or text 744-3278 in 518 area.