DK35vince
Super Member
It is a WR Long toothbar from Carver Equipment (60", around $305 delivered), slips over the bucket edge and held in by 2 bolts so its easy to install/remove.
need info on Kioti
- Thread starter ezzy
- Start date
- Views: 3667
TomK
Bronze Member
I'm looking for a new CUT to knock down the dead scrub oak on my hilly 5 acres here in Colorado. Would the CK20 have the power to pull a 60" brush hog over steep hills? My Ford 8N is lacking in the power department and I’m getting to old for the excitement of bad brakes. /forums/images/graemlins/tongue.gif Is the CK20 the same size as the Kubota BK23? When will the CK25’s and CK30’s come out?
Golfgar4
Elite Member
- Joined
- Feb 21, 2002
- Messages
- 4,342
- Location
- Janesville, Wisconsin
- Tractor
- None -yet. Until then FunBuggy (EZ-Go) will have to do!
According to this thread Kioti's CK25 and CK30 makes North American Debut in THIS forum, this month! /forums/images/graemlins/wink.gif /forums/images/graemlins/grin.gif
depratt_equip
Platinum Member
The CK20 is a little to small of a unit to be using a 5ft cutter. I would stick with a 4ft unit or 52" at the max. The new CK25 and CK30 should be out sometime this spring to mid summer from what i hear. If you really want hydro then i would hold out for the CK25 or 30 if i were you. If you don't need hydro then check out the LK2554 or LK3054.
The CK20 is physically a bit bigger than the BX23. The engine and PTO HP on both units are about the same. The CK20 does weigh in about 400lbs more than the BX23. It also has a higher flow hyd pump vs the BX23. 7.66Gpm on the CK20 vs. 5.5gpm on the BX. CK20 also has more lift capacity on the 3-pt.
The CK20 is physically a bit bigger than the BX23. The engine and PTO HP on both units are about the same. The CK20 does weigh in about 400lbs more than the BX23. It also has a higher flow hyd pump vs the BX23. 7.66Gpm on the CK20 vs. 5.5gpm on the BX. CK20 also has more lift capacity on the 3-pt.
TomK
Bronze Member
I was thinking I needed something over 25hp, but the CK20 looked pretty good from what I’ve read on TBN. Thanks for the input. Maybe it would be cheaper to include a new 48" brush cutter in a package than buying a larger tractor if the CK20 has the power to bash through the scrub oak.