Need hydro adapters

[Taxidermist]

I am adding rear remotes to a Branson 3510 I was told i need adapters to go from MM to jic/pipe

Here is what i am looking for 20mm x 1.5 pitch ORB adapter in each hole that comes out to a JIC or pipe

I cant find any. I sent a e mail to davestractor but have not heard from him yet.

Thank you,
Rob

 

[Zebrafive]

I am finding listings forM18 x 1.5 and M22 x 1.5, but M20 x 1.5. Are you sure of the size?

 

[Taxidermist]

I am finding listings forM18 x 1.5 and M22 x 1.5, but M20 x 1.5. Are you sure of the size?

Nope! I was told that was the size by a member here davestractor.



"Just about directly under the seat on the right side of the rear axle housing up high, but still on the side (not the top) is a pair of banjo fittings right next to each other that are actually connected. Remove those and install a 20mm x 1.5 pitch ORB adapter in each hole that comes out to a JIC or pipe and you are good to go. The front port is pressure, the rear continues the flow. We've done dozens, but by the time you get a nice two or three spool valve and a top and tilt cylinder, then spend several hundred on hoses, fittings, disconnects, etc...it still gets expensive."

 

[Zebrafive]

Discount Hydraulic Hose has the fittings you need.
Male M20 x 1.5 to Male JIC.
Metric side includes washer and O-Ring
Item 9065S-06-S12-20 has #6 (3/8") JIC Male
Item 9065S-08-S12-20 has #8 (1/2") JIC Male
Item 9065S-10-S12-20 Has #10 (5/8") JIC Male

 

[MtnViewRanch]

Dave was at the Tulare World Ag Expo this past week, I'm sure that he will get back with you as soon as he can.

 

[Taxidermist]

Thank you!!!!


Rob