Need Help, Lights, I must be dummer than most

PineRidge · Apr 12, 2005

Well if your switches are rated correctly then you shouldn't have a problem at all.

If you do I would suspect that it will be because of a switch overheating but that should be pretty obvious if it does as things might get warm at the switch.

If it turns out that you do need a relay I will be more than happy to supply a wiring diagram for your needs.

tommu56 · Apr 21, 2005

use towmotor connectors the 50 amp size I even have them under my hood I have 350 amp ones to plug my jumper cables in to.

http://www.andersonpower.com/products/mp/sb.html

notamustang · Apr 21, 2005

Those conectors are great I use them for my inverter and cables also. For the lights I would say that the 50A are way over kill, not that there is anything wrong with that but you can get a two conducter trailer conector with 14g wire which work great and are only two bucks at AutoZone.

MGB · May 27, 2005

Did you ever get this figured out? If not, I have some questions for you. I think I know what's missing if I'm understanding this correctly.

Casco1 · May 27, 2005

Get What figured out?

MGB · May 31, 2005

Wiring up your relay and lights. I didn't read the entire thread so, sorry if I missed it.

Casco1 · May 31, 2005

Hi, Everything is installed and working fine. I wired everything without relays because I couldn't get them to work. If you check page ten of this thread I posted pics of my setup. A few pages more and FREDS posted his setup. I got around the relays by using a little bigger wire.